It’s almost show time and we cannot wait to share with you all of the innovative solutions we are working on at this year’s BCMC show in Omaha. [For all photos, See PDF or View in Full Issue.] Innovative Software We are excited to announce our newest addition to our Component...

With the Component Solutions® Truss Studio™ design software, you can draw areas on a layout which allow you to block out a specific area, preventing newly created trusses from passing through the designated obstruction area. These obstruction spaces (designated as cube shapes) can...

We are just under two months away from the 2025 Building Component Manufacturers Conference (BCMC) in Omaha, Nebraska. Simpson Strong-Tie’s dedicated employees are excited to demonstrate our latest innovations in our booth this year. [For photos, See PDF or View in Full Issue.] Along...

Often, software users will not realize the full extent of features available to them in a program. Our CS Director™ and CS Truss Studio™ both offer extensive options, including the ones discussed here. You can create stack lists in both CS Director™ and CS Truss...

Simpson Strong-Tie has been a supplier of connectors for trusses and engineered-wood products for years. This experience has provided insights into the needs of the component manufacturer and has resulted in the development of innovative software that meets those needs. Our project management...

Simpson Strong-Tie’s Component Solutions® Director™ software creates an audit trail of user changes and displays this information on the History Tab for each project you are working on. The following historical Information displays when you click the History Tab: Pricing...

A benefit of using Simpson Strong-Tie’s CS Truss Studio™ is managing the relationship between the truss self-weight and the dead load. Truss self-weight is checked against all applied dead loads to verify that there is enough assumed “extra” dead load to account for the...

Uplift reactions are the result of a set of conditions that generally includes load types, load combinations, bearing locations, and web patterns. In most cases, especially those involving wind load combinations, uplift reactions are relatively small and can easily be resolved through the...

To strengthen a truss member or web, add a scab to reinforce it. For example, if you have a point load in the middle of a panel, one or two scabs may be used instead of increasing the grade or size of the member or using a multi-ply truss. Scabs reinforce overhangs by enhancing bending and...

One of the features of using Simpson Strong-Tie’s Component Solutions® CS Truss Studio™ software is the ability to add Attic Tie-Beam functionality. [For all images, See PDF or View in Full Issue.] To create an attic truss:      1. Create a new truss or...