Library

Building history facts: Before the 2008 financial crash, there were about 2,100 wood truss and wall panel component manufacturing (CM) companies across North America. The vast majority of the locations were independently owned and operated. When the worst of the effects of the recession finally...

Recently, while conducting an ANSI/TPI audit, a splice caught my eye. When I investigated further, I realized that the bottom chord of the truss I was investigating had a very short, 2” chord segment. I immediately assumed the truss builders had cut a short block to make up for a miss-cut...

May 1st means that early-bird registration has opened, so it’s time to start planning your trip to join us in Indianapolis for this year’s Building Component Manufacturers Conference (BCMC)! As a member of SBCA’s BCMC Committee, I always have a personal stake in the success...

Dealing with the industry’s long machinery lead times actually has given everyone an opportunity to get creative, to stop procrastinating, and to complete those naggingly important process improvement projects — even though that’s easier said than done! This month, I am...

Skills shortages, increased costs, margin pressures, and continued demand for new builds across the housing market have in recent years accelerated the focus on automating the prefabrication of lumber wall frames, roof trusses, and lumber floors. Today, the prefabrication of lumber wall frames...

If there is a lesson to be learned from the recent collapse of Silicon Valley Bank in March, and the ripple effect that caused a run on Signature Bank, along with the staggering declines in the share prices of First Republic Bank and PacWest Bancorp, it is this: it’s unwise to depend...

With the loan in-hand, for construction to begin the next hurdle is permits. In my case, I received a combined shop/home permit, rather than separate permits for our house and then our shop. Even the building commissioner said I had put the cart before the horse, but we needed to build the shop...

Last month’s article, “The Designer Shortage—Where Can We Find Them?”, offered some suggestions for finding new component designers. This month, I have some suggestions for training those new hires effectively. And bear in mind, as I mentioned last month, I think it is...

At the start of a new quarter, the economy is continuing its bumpy ride toward recovery while still showing mixed signals. Forecasts going forward are for slower growth throughout the next two quarters before picking up steam in the latter part of this year and going into the next. There are...

When designing trusses for special loads or special conditions, it is important to define the individual truss members correctly. Without proper member definitions, trusses could be inadvertently under-designed and/or have incorrect analog. The most common member types are webs and chords. Top...