Library

My March article, “Prevent Scope Creep Becoming ‘Just the Way We Do Things’,” talks about drawing clearer boundaries so extra work doesn’t quietly erode margins, burn out designers, and reset customer expectations. While all of that matters, it would be unrealistic...

The MSR Workshop has a solid reputation for providing practical, real world learning, and this spring’s program in Orange Beach, Alabama is shaping up to be one of the strongest yet. The 2026 agenda features two concentrated blocks of educational sessions — Thursday morning (8 am to...

Like many stories, this one started with a rumor: Builders FirstSource was closing two stores in Iowa, a dealer told me. Digging into that story revealed a much bigger tale involving how actively America’s biggest full-service lumberyard has been shedding some underperforming locations...

A chase is an intentional opening in a floor truss created by omitting specific diagonal webs to provide space for HVAC ducts, plumbing lines, or electrical runs. For structural efficiency, chases should be located within the middle third of the truss span, where shear forces are lowest....

The “Inspect” tool in Plate Monitor (Joint Properties) is a little known and certainly underutilized tool in the Truss Studio design software that can help you quickly deal with joint plating changes and issues. [For all images, See PDF or View in Full Issue.] We developed this tool...

Innovation in the structural building components industry does not always come from sweeping, disruptive change. Often, it begins with practical ideas, incremental improvements, and solutions born directly from jobsite challenges. The SBCA Innovation Grant is designed to bring those ideas...

Jerry Koskovich, inventor of the first robotically controlled truss equipment, passed away March 17, 2026. Jerry was a singularly gifted entrepreneur who started from scratch in the truss industry as a TPI QC inspector in Minnesota in 1973. While doing his inspections on the shop floor in many...

As we focus on our daily work tasks, it’s very easy (too easy) for us to forget how we’re simultaneously in an industry where we have not just colleagues but friends. We concentrate on specific projects and deadlines, blocking out distractions that could seemingly slow down our...

Wood was not held in high regard in the truss drafting department where I began working. Our fabricator customers often wanted their trusses designed with “old lumber,” meaning the obsolete size of 1-5/8” x 3-5/8”, even though the 1.5” x 3.5” size had been in...

Our industry design standard, ANSI/TPI 1, regulates numerous elements in constructing roof and floor trusses. The following is a brief non-exhaustive summary: Lumber grades and moisture content Pedigree of lumber grades and lumber management Controls on truss profiles Verification of...