Last month’s fine article by Glenn Traylor, “How Do I Choose Which Plates for a Critical Plate Inspection?”, reminded me of investigative experiences I’ve had throughout my career. The work of truss builders is extremely important, as evidenced by instances of truss...

The requirement is: an inspector will, on average, inspect one critical plate for every inspection made during a week. That requirement is the baseline number for the quantity of critical inspections to perform—but because some trusses do not have critical plates, it’s necessary to...

A critical plate is a plate with a Joint Stress Index of 80% or greater. The ANSI/TPI 1–2014 Standard stipulates that critical plate inspections must be conducted when completing the three inspections per station/per shift/per week requirement. On average, the standard requires one...

When a 3rd party inspector inspects a licensed plant, what exactly are the auditors looking for? And what can the fabricator get from the experience? What the inspection is NOT, and why that matters: The part 1 audit of the in-house paperwork is not a grade on neatness. It’s an...

The purpose of this article to examine the significance and implementation of a typical note that appears on metal plate connected roof-truss drawings when a top-chord-pitch of ¼:12 or less is specified by the Construction Documents. Three questions will be addressed: What is the...

Per ANSI/TPI 1–2014, National Design Standard for Metal Plate Connected Wood Truss Construction, plates should be installed within a 10 degree tolerance. So what happens when the plate is rotated and exceeds this requirement? The simple answer is: the configuration and design of...

Roof and floor trusses are important components that need special consideration to insure their correct manufacture. Components built to the IRC and IBC require the manufacturer to adhere to specific requirements. These requirements provide a blueprint to facilitate the manufacturing of a...

Introduction Custom kitchens, with high-end appliances, granite countertops, and central islands, are becoming more and more prevalent in the home market today. These products and finishes are heavy and the dead loads from the central islands and/or cabinets positioned along interior...

The lack of attention to the moisture content (MC) of lumber used in truss manufacturing can cause or contribute to in-service performance issues. Mr. Glenn Traylor’s fine article in the September issue of The Advertiser, “Does Your Lumber Have a Shelf Life?”, was greatly...

Generally, building design refers to the broadly based architectural, engineering, and technical applications to the design of buildings. Therefore, all building projects require the services of a building designer. Statutorily, the required credentials of a building’s designer vary from...