After recently upgrading to a newer vehicle, I have been amazed at the new safety features. While it’s not self-driving, the features are definitely approaching an autonomous car. The basic functions are things like active cruise control with the “stop&go” function, which...

Per ANSI/TPI 1–2014, National Design Standard for Metal Plate Connected Wood Truss Construction, plates should be installed within a 10 degree tolerance. So what happens when the plate is rotated and exceeds this requirement? The simple answer is: the configuration and design of...

Roof and floor trusses are important components that need special consideration to insure their correct manufacture. Components built to the IRC and IBC require the manufacturer to adhere to specific requirements. These requirements provide a blueprint to facilitate the manufacturing of a...

Just like some foods, lumber kept in the right environment will store for an indefinite length of time. But just like food, lumber kept in sub-par conditions will have a shortened storage period. If you’re not storing your lumber properly, you may have to question whether it can/should...

The most common problem typically encountered is excessive defects in the plated area of the truss. While some defects are acceptable in the plated area, the degree of defects depends on the actual joint situation and forces at the joint. Connector sizes are controlled by design, handling,...

How the product will be used is a very important consideration when designing components, and it also comes into play during fabrication. The attic trusses in the photograph have a wedge installed at the wall–ceiling intersection. This is the intended design. Deeper in the rack,...

Everyone knows that member gaps can be caused by uncalibrated saws and poor jigging stops during truss set-up. But did you know the most likely cause of member gaps is the lumber carriage shifting or moving the lumber at an angle, thereby causing a skewed cut? This is especially true when a gang...

A process that requires the inspection of each individual unit or component received from a process or manufacturer is said to be “100 percent inspected.” When fabricators initially consider a quality program, this is what they imagine is necessary. This 100% process, however, is...

Picking usable lumber involves more than just the initial grade stamp. We can think of the stamp as the first step, but we can’t stop there. Truss fabricators depend on the lumber supplier to provide effective grading protocols that will produce materials with predictable design values....

The lowly wedge sometimes gets very little respect. If your plant is doing it right, the wedges usually are cut from drops or culls. That’s a good way of doing it, and it sounds very simple, but not just any piece of wood is suitable for a wedge. There are important qualifications that...