The old joke is: “What time is it when an elephant sits on your fence? Time to get a new fence.” So what time is it when your floor trusses look like this? It might be time for a new floor machine or at least some attention. In the photo [See PDF or View in Full Issue], the floor...

The Advertiser - June 2017 | Page #30 Compliance with ANSI/TPI 1–2014 requires maintaining member to member gaps at less than 1/8 inch. An exception would be for floor truss chord splices where the limit is 1/16 inch. While building trusses, the code calls for tight joints. In a...

The largest expense in a truss plant’s operation is the lumber cost. It often represents 50% to 60% of the selling cost of the truss. With such a high percentage, most managers are always focused on saving lumber, optimizing lumber, and searching for the best price. Those aspects are...

For many years, wood frame wall panels have been constructed on site by contractors, and, in more recent times, by component manufacturers too. The wall panels assembled by component manufacturers primarily are open panels. These consist of lumber studs at predefined centers sheathed externally...

What makes up a great Quality Assurance Program? As you’ll recall, I listed 9 essential components for good QA in an article last year, “How Does a Fabricator Gain From a 3rd Party Audit?”. It’s no surprise that each one is rooted in the personal, on-site interaction that...

Eleanor Roosevelt once said, “Learn from the mistakes of others. You can’t live long enough to make them all yourself.” Apparently, she never worked in a truss plant, where I think everyone will make them all at least once. But humor aside, let’s take a look at the...

Back in the days before Autoset C®, Matchpoint®, and Wizard®, truss set-ups and the truss profile were dependent on the truss builder’s ability to accurately jig the truss being built using cross reference information and data. For example, a heel to peak measurement was taken...

On a recent trip to Japan to observe construction manufacturing methods, I was struck by the amount of time a plant manager spends on the production floor. Comparing this Japanese methodology to our truss industry, our plant managers and upper management spend relatively little time engaged in...

Do you vertically stack your trusses or horizontally stack them? How does the method impact quality? How does it impact safety? Do you know the arguments for either preference? Almost as if it was a regional inclination, some areas of the US vertically stack their finished trusses and some areas...

Recently, I was asked to divert from my normal 3rd party agenda to make a special truss inspection. Although this seemed a little unusual, on occasion I am asked to do this sort of thing, so I didn’t pay it any mind. Normally, it’s a peculiar joint condition or a difficult plate...