Are You Making Correct Substitutions and Placements When Upsizing Connectors? Glenn Traylor Sometimes it is necessary to deviate from the truss design drawing and use a different connector. This may happen when a specific size connector is not available or when the original connector has been removed. Per ANSI/TPI 1 Section 3.6.3, a metal connector can be substituted if the new... Read More January 2023 Issue #15282 Page 35
Why Do I Need the Software Polygons? Glenn Traylor When completing an in-house inspection, a critical plate inspection is required for each truss inspected. This requirement is from ANSI/TPI 1–2014. Specifically, per section 3.7.1: No less than one critical joint per Truss selected for inspection, on average across all operational... Read More December 2022 Issue #14281 Page 35
Are You Removing the Connectors Carefully When Replacing Them? Glenn Traylor Face the facts—occasionally, it is necessary to replace connectors. It’s part of the manufacturing process. In my May 2016 article, Is There a Reduction For Plating in a Previously Plated Area?, we discuss the limitations and considerations of removing a plate, including upsizing the... Read More November 2022 Issue #14280 Page 33
Are You Counting Your Teeth Correctly? Glenn Traylor On occasion, we are required to utilize a detailed tooth count to qualify a connection on a metal plate connected wood truss. Fortunately, we have several tools that can assist us. My June article, “Which is Better: Plate Placement Method or Tooth Count Method?”, includes a... Read More October 2022 Issue #14279 Page 33
Are You on Target for Quality? Glenn Traylor Is your operation on target when it comes to quality? September is your chance to find out! At BCMC Omaha last year, our Timber Products Inspection booth gave all attendees the chance to test their skills and acumen for Quality Assurance. This year at BCMC Columbus on September... Read More September 2022 Issue #14278 Page 31
What is the Value of a Floating Chase? Glenn Traylor The development of the 4 x 2 floor truss system revolutionized the truss industry. Plating to the narrow edge of the chord members presented some issues, but all in all it allowed component fabricators another product offering, expanding their potential business. In the original designs, it was... Read More August 2022 Issue #14277 Page 29
Standards Ensure Off-site Built Tiny Homes Deliver Safety and Efficiency Ryan Colker As many communities and potential homeowners struggle with housing affordability, tiny houses have emerged as part of the solution. Assuring these tiny houses deliver the same level of safety and efficiency of other permanent housing solutions is essential. Local building codes and the... Read More August 2022 Issue #14277 Page 96
What are the Minimum Grade Requirements for Lumber When Manufacturing Components? Glenn Traylor With high lumber costs and volatile pricing, it is very reasonable to look for options to normal resources. Many fabricators and lumber manufacturers have been experimenting with using non-regular channels for lumber, including some choices that have created problems and issues with their... Read More July 2022 Issue #14276 Page 39
Which is Better: Plate Placement Method or Tooth Count Method? Glenn Traylor To answer the question of which is the better method, we should start with a little background. A critical plate is a plate with a Joint Stress Index of 80% or greater. The ANSI/TPI 1–2014 Standard stipulates that critical plate inspections must be conducted when completing the three... Read More June 2022 Issue #14275 Page 39
Is Perfect Lumber Required to Make Great Trusses? Glenn Traylor Due to the nature of wood, lumber characteristics can vary in every piece. Even “in grade” lumber can have drastic variations in performance. How can we deal with and adjust for natural defects and variability? We have discussed roof trusses in previous articles, including... Read More May 2022 Issue #14274 Page 43