Library

With remote going viral and people jumping into it without knowing all of the trade-offs, it’s time to start a conversation about the good, the bad, and everything in between. Let me know what you would add to the following lists, and send me your opinions about working remotely. Some...

ANSI/TPI 1, Chapter 2 As a truss technician or component manufacturer, have you ever been asked to perform duties that fall outside of ANSI/TPI 1, Chapter 2 guidelines? We know in our previous roles as truss technicians and component manufacturers, we were often requested to perform a task...

What is driving the quest for automation besides the obvious? Surely it is not our preoccupation with the past, because that would recall the recent near-depression, and painful past calamities. Rather it is prospection, looking ahead, that explains much of our behavior, according to...

Here in the 21st century, we like to believe that technology is infallible. Computers and circuits, electrical impulses and networks—if everything is in proper working order, won’t it all work perfectly? It’s reassuring to believe that people make mistakes while computers...

Automation is advancing around the world, but will it yield the quantum leap promised? And how big a margin will it provide over conventional processes? Let’s first assess how various systems affect non-direct-labor inputs to the production process. Later we’ll balance these against...

I have attended my share of trade shows over the years, from work events to leisure activities. Every time I attend, I consider the effort put forth to assemble each booth. Displays range from pop-up displays, while others are thrown together overnight or on strict budgets. Then you come upon...

Too often a repeated mantra within our industry is that everyone sells components at too-low margins. The blame is always on the other guy, meaning the competitor, for selling at a lower margin than what should be market pricing. Well, what can your company do to raise margin pricing? During...

Compliance with ANSI/TPI 1–2014 requires maintaining member to member gaps at less than 1/4 inch. An exception would be for floor truss chord splices where the limit is 1/16 inch. Let us take a look at two different situations, the first being a roof truss and the second being a 4 x 2...

Part 5 in our TIMWOODS Series Piles and piles of production all around you. No, I am not talking about inventory, I am talking about WIP, finished goods/staged jobs—Overproduction. Overproduction is making products in too great a quantity or before actually needed, leading to excessive...

When our Salesman, Ross Black, gave me the plans for the Clark Residence, I knew from the start that this was going to be a special project. I always enjoy working on these large single family custom homes, and this was no exception. For the most part, this home was not too difficult of a...